| 过电压保护器原理及结构特点介绍 |
| 添加时间：2017/12/28 14:14:04 浏览次数： |
| 过电压保护器原理 Principle of overvoltage protector 过电压保护器工作原理：FR为氧化锌非线性电阻，CG为放电间隙，由于采用对称结构，因此无论是相间还是相对地，都有相同的过电压保护倍数。 The working principle of over voltage protector is that FR is a nonlinear resistor of Zinc Oxide, and CG is a discharge gap. Because of the symmetrical structure, there is the same overvoltage protection multiple between phases. 过电压保护器一共有四个保护单元，其中三个接入系统的A、B、C三相，另一个接地。 The over-voltage protector has four protection units, of which three access systems are A, B, C three-phase, and the other is grounded. 131型过电压保护器为三立柱式，因此三立柱可任意在A、B、C三相之间调换安装，接地相必须接地安装。 The 131 type over-voltage protector is three column type, so the three column can be changed and installed between the A, B and C three-phase, and the ground phase must be grounded. 过电压保护器结构特点 Structure characteristics of overvoltage protector 三相组合式过电压保护器过电压保护器与传统的避雷器以及其它同类产品相比，有不可比拟的特点： Compared with traditional lightning arresters and other similar products, the three phase combined overvoltage protector overvoltage protector has unparalleled features. 1.采用氧化锌非线性电阻和放电间隙串联的结构，使两者互为保护;放电间隙使氧化锌非线性电阻的荷电率为零，氧化锌的非线性特性又使放电间隙动作后立即熄弧，无续流、无截波，放电间隙不再承担灭弧任务，提高了产品的使用寿命，在操作过电压下，动作寿命可达105次; The structure of the 1. Zinc Oxide nonlinear resistance and discharge gap series, make each discharge gap protection; make Zinc Oxide nonlinear resistance charge rate is zero, the nonlinear characteristics of Zinc Oxide and the discharge gap action immediately after extinction, free wheeling, clipping, discharge gap arc no longer bear the task, improve the product life in the operating voltage, operating life can be up to 105 times; 2.电压冲击系数为1，在各种电压波形下，放电值均相等，不受操作过电压类型影响，过电压保护值准确，保护性能优良; 2., the voltage impact coefficient is 1. Under various voltage waveforms, the discharge values are equal, which is not influenced by the operation overvoltage type, and the overvoltage protection value is accurate and the protection performance is excellent. 3.采用四星形接法，可将相间过电压大大降低，与常规避雷器相比，相间过电压降低了60～70%，保护的可靠性大为提高; 3., the four-way connection method can reduce the interphase overvoltage greatly. Compared with the conventional lightning arrester, the interphase overvoltage is reduced by 60 to 70%, and the reliability of protection is greatly improved. 4.采用硅橡胶外套和高压电缆外引结构的过电压保护器，除具有瓷绝缘外套的电气性能外，还具有易安装、密封性强、体积小、耐震(振)动等优点，可直接安装在开关柜的手车底盘上或互感器室内; 4. using silicone rubber coat and high voltage cable external overvoltage protector structure, besides the electrical performance of porcelain insulating sleeve, also has easy installation, good sealing performance, small volume, shock (vibration) dynamic advantages, can be directly installed in the switch cabinet handcart chassis or transformer room; 5.使用环境温度为-40℃～+60℃，海拔高度小于2000m，(高于2000m，在订货时请注明); 5. the environment temperature is -40 C ~ +60 C, the altitude is less than 2000m, (higher than 2000m, please note in order). 6.在系统发生间歇性弧光接地过电压及铁磁谐振过电压，若其能量小于2ms.400A方波冲击能量时，过电压保护器可以起到保护作用。 6., when the system occurs intermittent arc grounding overvoltage and ferromagnetic resonance overvoltage, if the energy is less than the 2ms.400A square wave impact energy, the overvoltage protector can play a protective role. |
| 上一页 雷电过电压保护器件 |
| 下一页 过电压保护器原理 |
Copyright © 技术支持：遨游网络