| 绝缘导线过电压保护器安装工艺 |
| 添加时间：2017/12/2 14:32:34 浏览次数： |
| 摘要】绝缘导线过电压保护器安装工艺规范： 1、绝缘导线应放在柱式瓶中间凹槽内（不得放置在侧槽内）。 2、过电压保护区不锈钢引流环与绝缘导线线芯之间的间隙要控制在1005mm范围内，引流环与绝缘子之间的间隙必须均匀，控制在255mm范围内。 3、对于不剥除绝缘层的...... The installation process specification of the overvoltage protector for insulated conductor: 1, insulated wire should be placed in the slot in the middle of the cylinder (not in the side slot). 2, overvoltage reserve stainless steel drainage clearance between ring and insulated conductor wire core to control within the scope of the 1005 mm, drainage of the clearance between the ring and insulator must be uniform and controlled in the range of 255 mm. 3, for the... 绝缘导线过电压保护器安装工艺规范： Installation process specification for insulated conductor overvoltage protector: 1、绝缘导线应放在柱式瓶中间凹槽内（不得放置在侧槽内）。 The insulated conductor should be placed in the slot of the cylinder. 2、过电压保护区不锈钢引流环与绝缘导线线芯之间的间隙要控制在100±5mm范围内，引流环与绝缘子之间的间隙必须均匀，控制在25±5mm范围内。 2, overvoltage reserve stainless steel drainage clearance between ring and insulated conductor wire core to control within the scope of the 100 + / - 5 mm, drainage of the clearance between the ring and insulator must be uniform and controlled in the range of 25 + / - 5 mm. 3、对于不剥除绝缘层的架空均匀线路，三相引流环圆弧应朝同一方向外置，以免引流环之间间隔过小，影响架空线路绝缘配合。 3, are not uniform removal of insulation overhead line, the three-phase flow loop outside the arc should be in the same direction, in order to avoid the drainage intervals between ring is too small, affect the overhead line insulation coordination. 4、安装前过电压保护器应采用不低于5000V的兆欧表进行绝缘电阻测试，在干燥的情况下，绝缘电阻不低于1000兆欧。 The overvoltage protector should be used for insulation resistance test in the 5000V meter, and in the dry case, the insulation resistance is not less than 1000 megaohm. 线路避雷器安装 Line arrester installation 工艺规范： Process specification: 1、避雷器安装应符合下列规定：顶端顺线路歪斜不应大于10mm。 The installation of arrester should meet the following rules: the top line should not be larger than 10mm. 2、安装前避雷器应采用不低于5000V的兆欧表进行绝缘电阻测试，在干燥的情况下，绝缘电阻不低于1000兆欧。 The lightning arrestor should be used for insulation resistance test not less than 5000V. In dry case, the insulation resistance is not less than 1000 megaohm. |
| 上一页 电气系统的内部过电压触发的原因 |
| 下一页 家用电器滤波功能的插排 |
Copyright © 技术支持：遨游网络