湖北武汉空压机诚信厂

1、过电压保护器相间过压保护原理

1. Overvoltage protection principle of overvoltage protector

过电压保护器当A，B，C三相中，任意两相发生过电压时，P1，P2，P33个保护单元中的相应两相则通过各自的间隙组件两两并联后，再通过P4放电保护，过电压保护器的氧化锌阀片导通限压。过电压消失后，因氧化锌阀片的泄漏电流很小，放电间隙组件自动恢复。

The overvoltage protection device when A, B, C three-phase, arbitrary phase overvoltage, P1, P2, P33 protection units in the corresponding phase of the respective 22 parallel components through the gap, and then through the P4 discharge protection, overvoltage protection valve for Zinc Oxide conduction pressure limit. After the overvoltage disappears, because the leakage current of the Zinc Oxide valve is very small, the discharge gap component is automatically restored.

2、过电压保护器相对地过压保护原理

2 、 overvoltage protection principle of over voltage protector

当A，B，C三相中，任意一相与地发生过电压时，P1，P2，P33个保护单元中的相应一相和接地相P4之间通过各自的间隙组件串联放电保护。

When the overvoltage occurs in any phase of the A, B, C three-phase, the series of discharge protection between the corresponding phase and the ground phase P4 in the P1, P2, P33 protection units are connected by their respective gap components.