返回首页

湖北武汉空压机诚信厂

本站导航

新闻动态

当前位置:网站首页 > 新闻动态 > 详细信息
过电压保护器的使用条件
添加时间:2017/9/5 15:49:06     浏览次数:
过电压保护器的使用条件 Conditions for the use of over voltage protectors 1、适用于户内、外(详见具体产品型号); 1, suitable for indoor and outdoor (see specific product model); 2、环境温度-40℃ ~ +40℃; 2, environmental temperature -40 degrees C ~ +40 DEG c; 3、海拔高度2000m及以下(高于2000m应选用专用高原型产品); 3, altitude 2000m and below (higher than 2000m should choose special plateau products); 4、电源频率不小于48Hz,不大于62Hz; 4, the power frequency is not less than 48Hz, not greater than 62Hz; 5、地震烈度8度及以下; 5, the earthquake intensity of 8 degrees and below; 6、最大风速35m/s及以下; 6. Maximum wind speed 35m/s and below; 7、重污秽及以下; 7, heavy pollution and the following; 8、对有间隙结构,安装点短时工频电压升高不应超过保护器额定电压; 8, for the gap structure, the installation point of short-term, power frequency voltage shall not exceed the protection device rated voltage; 对无间隙结构,安装点持续电压波动不应超过保护器持续运行电压; For gapless structures, the mounting point voltage fluctuation shall not exceed the continuous operating voltage of the protector;
上一页  详解变压器的过电压保护  
下一页  过电压保护器原理
  • 关于我们
  • 新闻动态
  • 案例展示
  • 网上订单
  • 联系我们
  • 产品分类1
  • 产品分类2
  • 产品分类3

Copyright © 技术支持:遨游网络

  • 联系我们
  • 网上订单
  • 工程案例
  • 本站导航

搜索

  • 关于我们
  • 新闻动态
  • 案例展示
  • 网上订单
  • 联系我们
  • 产品分类1
  • 产品分类2
  • 产品分类3